Objectives:
- To build an proper hydroelectric prototype.
- To build a device that can convert the mechanical flow energy (water) into usable electric energy.
- To make an enclose, since the hydroelectric use a turbine, act to prevent a water leakage.
Content / Procedure:
- Make a research about suitable material like PVC, aquarium, metal and so on.
- Done a cost analysis towards suitable material.
- Make an early design by using an AUTOCAD software to visualize the prototype.
- Make an early survey while buying the material.
Result and Analysis:
- I'm begin to considering a suitable frame towards this mater.
- I'm decided to work with something easy to deal with, strong and light as possible. The material should be a non - conductor.
- This leads mine to choose a PVC pipe and plastic aquarium, while the turbine and shaft part will be hold by it's shaft installed on the metal frame.
- The early design using an AUTOCAD software are been done, and the design is was shown below:
FRAME SCHEMATIC: FULL VIEW |
FRAME SCHEMATIC: SIDE VIEW |
FRAME SCHEMATIC: TOP VIEW |
FRAME SCHEMATIC: TURBINE BOX |
FRAME SCHEMATIC: BELOW |
- As the PVC pipe is non - conductor which will greatly prevent any electric shock dangers while i work in the wet environment such as bathroom, toilet and so on.
- The cost also is considerably affordable and not too high.
- This is an early design, an any modification towards the hydroelectric prototype are been a analysed during troubleshooting.
Conclusions
Kenali Abdul Syafiq :
Mr.TN_SkY juga adalah penulis untuk blog STORY PONDOK KECIL dan INFO HARIMAU MALAYA. Birdies boleh mengikuti SkY di Twitter atau di Facebook. Jika birdies mempunyai soalan, boleh like fanpage pondok kecil ye, Pondok Kecil Crew.
No comments:
Post a Comment