WEEK 8: MECHANICAL CONSTRUCTION

Objectives: 

• To make an configuration of the hydro material.
• To build a proper hydroelectric prototype.
• To check an suitable approach that can meet the goal of the project.

Content / Procedure: 

• Make a configuration based on specification on each material.
• Understand the function of each mechanical items.
• Justify the cost and what component to be used.
• Troubleshoot the prototype in order to determine problem.

Result and Analysis:

• This project did not have a software programming because of the higher cost, and based on the objective project itself. 
• In other means, the mechanical material is one of the parts that need to be focusing on during this project.
• The mechanical material must be done properly. It is because, hydroelectric systems is depend on the accurate place, timing and proper design in order to produce a right output.
• The work load during this part has been shown below:

• The early configuration of the hydroelectric systems ( before pulley systems are been installed) has been done to check the performance of the turbine and alternator first.
• It must be done because, the arrangement of pulley that involving belting is critical; which is a little mistake can disturb a rotation of pulley.
• The arrangement of mechanical part has finish 70 percent and ready to be test.
• The result get is unsatisfied and the mechanical troubleshoot need to be done.

Conclusions

• Finish a configuration towards alternator and turbine.
• Make an enclose towards prototype.
• The early testing shown the prototype can not produce a right output, and the mechanical troubleshoot has been done.

---

Kenali Abdul Syafiq :

Mr.TN_SkY juga adalah penulis untuk blog STORY PONDOK KECIL dan INFO HARIMAU MALAYA. Birdies boleh mengikuti SkY di Twitter atau di Facebook. Jika birdies mempunyai soalan, boleh like fanpage pondok kecil ye, Pondok Kecil Crew.