Objectives:
- To test a level of understanding for my final year project.
- To present about hydroelectric generator; the performance or what have been achieved.
- To improve myself, in term of knowledge, presentation and communication.
- Refer to FYP scheme, presentation degree semester 2 to prepare a material.
- Discuss with supervisor, about how to tackle the question.
- Done a more research about basic knowledge of hydroelectric generator.
- Prepare a video as an supported material.
- Ensure the prototype in high good condition.
- I'm done a slideshow, poster and a few testing towards hydro prototype to ensure it work properly during presentation.
- The presentation will be conducted by 2 referee.
Objectives:
- To discusses on the result, analysis and performances that are encounter in the final result.
- To evaluate the effectiveness and ensure whether it had meed the outlined objectives successfully.
- To compare a result from three different methods.
- Make a comparison table between the three methods which is prototype testing, calculation and simulation.
- Make an analysis for inverter circuit.
- Do a hydroelectric prototype troubleshooting.
- Check the output current either the load can be powered or not.
- A power inverter is a device that converts DC 9direct Current) power into AC (Alternating Current) power.
Objectives:
- To prove an inverter performance.
- To analyse the right output inverter circuit.
- To Check a misconduct (mistake) while doing early inverter circuit.
- Make a research about inverter calculation.
- Make an analysis for basic inverter circuit
- Consider any losses during inverter operation.
- Try to collect information about inverter circuit before started calculating.
- The power output rating of the inverter chosen (in VA or n Watts is directly dependant on the load that will be powering.
Objectives:
- To make a configuration of changeover circuit.
- To gain an understanding about transfer switch operation.
- To produce output that can match the transfer switch limit.
- Make a research about transfer switch circuit.
- Complete a configuration of transfer switch.
- Do a component test. Collect an old component that have been used in order to reduce a cost.
- Hydroelectric generator must produce an approximately voltage to enable the supply line.
- The transfer switch involve an under voltage relay, 240 V relay, contactor, circuit breaker, photocell sensor and etc.
- The change over process happen approximately 2.5 second.
- The pictures of transfer switch are been shown below.
